The influence of nickel loading on reducibility of NiO/Al<sub>2</sub>O<sub>3</sub> catalysts synthesized by sol-gel method

Authors

  • Mohammad Zangouei Tarbiat Modares University, chemical engineering department, P.O. Box: 14115-143, Tehran,
  • Abdolsamad Zarringhalam Moghaddam Tarbiat Modares University, chemical engineering department, P.O. Box: 14115-143, Tehran
  • Mehdi Arasteh Tarbiat Modares University, chemical engineering departmen, P.O. Box: 14115-143, Tehran

DOI:

https://doi.org/10.3329/cerb.v14i2.5052

Keywords:

Nickel-alumina catalysts, Sol-gel method, Thermogravimetric analysis, Dispersion of NiO, Reducibility

Abstract

The sol-gel method was used to synthesize nickel-alumina catalysts with various nickel loadings. Chemical and physical properties of support and supported nickel were characterized by TGA, DTA, EDX, SEM, BET, XRD and TPR techniques. Calcination temperature (500°C) was determined by performing thermogravimetric and differential thermal analysis on the samples. Energy dispersive X-ray (EDX) was used to determine the actual content of nickel on alumina. N2 adsorption test revealed that the specific surface area varied between 550 and 223 m2/g for pure alumina and 30%Ni/Al, respectively. X-ray diffraction patterns showed no peaks due to NiO species and NiO species were well dispersed on the support by formation of NiAl2O4 phase. Temperature-programmed reduction (TPR) indicated that the nickel species mainly presented in NiAl2O4 phase and small amount of NiO. In the 20 percent nickel loading, the surface NiAl2O4 phase, which is between NiO and bulk NiAl2O4 phases in terms reducibility, was formed considering as a successful result.

Keywords: Nickel-alumina catalysts; sol-gel method; thermogravimetric analysis; dispersion of NiO; reducibility

DOI = 10.3329/cerb.v14i2.5052

Chemical Engineering Research Bulletin 14 (2010) 97-102

Downloads

Download data is not yet available.
Abstract
316
PDF
830

References

Pakizeh M, Omidkhah M and Zarringhalam A, Synthesis and characterization of new silica membranes using template-sol-gel technology, International Journal of Hydrogen Energy, 2007. 32(12):pp. 18251836. doi:10.1016/j.ijhydene.2006.07.025

Cheekatamarla PK and Finnerty C, Reforming catalysts for hydrogen generation in fuel cell applications, Journal of Power Sources, 2006. 160(1):pp. 490 499. doi:10.1016/j.jpowsour.2006.04.078

Natesakhawat S, Watson RB, Wang X and Ozkan US, Deactivation characteristics of lanthanide-promoted sol-gel Ni/Al2O3 catalysts in propane steam reforming, Journal of Catalysis, 2005. 234(2):pp. 496508. doi:10.1016/j.jcat.2005.07.014

Gonçalves G, Lenzi M, Santos O and Jorge L, Preparation and characterization of nickel based catalysts on silica, alumina and titania obtained by sol-gel method, Journal of Non-Crystalline Solids, 2006. 352(32-35):pp. 3697 3704. doi:10.1016/j.jnoncrysol.2006.02.120

Savva P, Goundani K, Vakros J, Bourikas K, Fountzoula C, Vattis D, Lycourghiotis A and Kordulis C, Benzene hydrogenation over Ni/Al2O3 catalysts prepared by conventional and sol-gel techniques, Applied Catalysis B: Environmental, 2008. 79(3):pp. 199 207. doi:10.1016/j.apcatb.2007.10.023

Hu L, Boateng KA and Hill JM, Sol-gel synthesis of Pt/Al2O3 catalysts: Effect of Pt precursor and calcination procedure on Pt dispersion, Journal of Molecular Catalysis A: Chemical, 2006. 259(1-2):pp. 51 60. doi:10.1016/j.molcata.2006.06.018

Kirumakki SR, Shpeizer BG, Sagar GV, Chary KV and Clearfield A, Hydrogenation of Naphthalene over NiO/SiO2-Al2O3 catalysts: Structure-activity correlation, Journal of Catalysis, 2006. 242(2):pp. 319 331. doi:10.1016/j.jcat.2006.06.014

Kim J, DONG J, Park T and Kim K, Effect of metal particle size on coking during CO2 reforming of CH4 over Ni-alumina aerogel catalysts, Applied Catalysis A, General, 2000. 197(2):pp. 191200. doi:10.1016/S0926-860X(99)00487-1

Zhang Y, Xiong G, Sheng S and Yang W, Deactivation studies over NiO/[gamma]-Al2O3 catalysts for partial oxidation of methane to syngas, Catalysis Today, 2000. 63(2-4):pp. 517 522. doi:10.1016/S0920-5861(00)00498-3

Shetty K, Zhao S, Cao W, Siriwardane U, Seetala N and Kuila D, Synthesis and characterization of non-noble nanocatalysts for hydrogen production in microreactors, Journal of Power Sources, 2007. 163(2):pp. 630636. doi:10.1016/j.jpowsour.2006.04.130

Sanchez-Sanchez M, Navarro R and Fierro J, Ethanol steam reforming over Ni/La-Al2O3 catalysts: Influence of lanthanum loading, Catalysis Today, 2007. 129(3-4):pp. 336345. doi:10.1016/j.cattod.2006.10.013

Vizcaíno A, Arena P, Baronetti G, Carrero A, Calles J, Laborde M and Amadeo N, Ethanol steam reforming on Ni/Al2O3 catalysts: Effect of Mg addition, International Journal of Hydrogen Energy, 2008. 33(13):pp. 34893492. doi:10.1016/j.ijhydene.2007.12.012

Kim P, Kim Y, Kim H, Song I and Yi J, Synthesis and characterization of mesoporous alumina with nickel incorporated for use in the partial oxidation of methane into synthesis gas, Applied Catalysis A: General, 2004. 272(1-2):pp. 157166. doi:10.1016/j.apcata.2004.05.055

Tang S, Ji L, Lin J, Zeng HC, Tan KL and Li K, CO2 Reforming of Methane to Synthesis Gas over Sol-Gel-made Ni/g-Al2O3 Catalysts from Organometallic Precursors, Journal of Catalysis, 2000. 194(2):pp. 424 430. doi:10.1006/jcat.2000.2957

Vos B, Poels E and Bliek A, Impact of Calcination Conditions on the Structure of Alumina-Supported Nickel Particles, Journal of Catalysis, 2001. 198(1):pp. 77 88. doi:10.1006/jcat.2000.3082

Li G, Hu L and Hill J, Comparison of reducibility and stability of alumina-supported Ni catalysts prepared by impregnation and coprecipitation, Applied Catalysis A: General, 2006. 301(1):pp. 1624. doi:10.1016/j.apcata.2005.11.013

Nguefack M, Popa A, Rossignol S and Kappenstein C, Preparation of alumina through a solgel process. Synthesis, characterization, thermal evolution and model of intermediate boehmite, Physical Chemistry Chemical Physics, 2003. 5(19):pp. 42794289. doi:10.1039/B306170A

Kim S, Lee Y, Jun K, Park J and Potdar H, Synthesis of thermostable high surface area alumina powder from sol-gel derived boehmite, Materials Chemistry and Physics, 2007. 104(1):pp. 5661. doi:10.1016/j.matchemphys.2007.02.044

Hao Z, Zhu Q, Jiang Z, Hou B and Li H, Characterization of aerogel Ni/Al2O3 catalysts and investigation on their stability for CH4-CO2 reforming in a fluidized bed, Fuel Processing Technology, 2009. 90(1):pp. 113121. doi:10.1016/j.fuproc.2008.08.004

Kim P, Joo J, Kim H, Kim W, Kim Y, Song I and Yi J, Preparation of Mesoporous Ni-alumina Catalyst by One-step Sol-gel Method: Control of Textural Properties and Catalytic Application to the Hydrodechlorination of o-dichlorobenzene, Catalysis Letters, 2005. 104(3):pp. 181189. doi:10.1007/s10562-005-7949-5

Alberton A, Souza M and Schmal M, Carbon formation and its influence on ethanol steam reforming over Ni/Al2O3 catalysts, Catalysis Today, 2007. 123(1-4):pp. 257264. doi:10.1016/j.cattod.2007.01.062

JIANG H et al., Tri-reforming of methane to syngas over Ni/Al2O3Thermal distribution in the catalyst bed, Journal of Fuel Chemistry and Technology, 2007. 35(1):pp. 7278. doi:10.1016/S1872-5813(07)60012-7

Downloads

Published

2010-11-11

How to Cite

Zangouei, M., Moghaddam, A. Z., & Arasteh, M. (2010). The influence of nickel loading on reducibility of NiO/Al<sub>2</sub>O<sub>3</sub> catalysts synthesized by sol-gel method. Chemical Engineering Research Bulletin, 14(2), 97–102. https://doi.org/10.3329/cerb.v14i2.5052

Issue

Section

Articles