To study the effect of grinding parameters on surface roughness and material removal rate of cylindrical grinding of heat treated en 47 steel

Authors

  • Mukesh Kumar Department of Mechanical Engineering, Punjabi University, Patiala
  • Sukhjinder Singh Department of Mechanical Engineering, Punjabi University, Patiala
  • Khushdeep Goyal Department of Mechanical Engineering, Punjabi University, Patiala

DOI:

https://doi.org/10.3329/jme.v45i2.28189

Keywords:

Cylindrical grinding, Mini Tab, Anova analysis, S/N ratio, Surface roughness, Material removal rate

Abstract

This research paper attempts to optimize the effect of input parameters to minimize surface roughness and maximize the material removal rate in cylindrically grinding of EN 47 steel material. Taguchi L18 (2)¹, (3)5 orthogonal array or mixed level of parameters have been applied to experimental design with the help of mini tab software. The result reveals that grain size and work speed are the most significant factors to influence material removal rate and surface roughness. The optimum set of input parameters for maximizing the material removal rate and optimum surface roughness have also been found

Downloads

Download data is not yet available.
Abstract
109
PDF
103

Downloads

Published

2016-07-28

How to Cite

Kumar, M., Singh, S., & Goyal, K. (2016). To study the effect of grinding parameters on surface roughness and material removal rate of cylindrical grinding of heat treated en 47 steel. Journal of Mechanical Engineering, 45(2), 81–88. https://doi.org/10.3329/jme.v45i2.28189

Issue

Vol. 45 No. 2 (2015)

Section

Articles