Lignin: a valuable feedstock for biomass pellet

Authors

  • SMA Sujan Department of Environmental Sciences, Jahangirnagar University, Dhaka-1342, Bangladesh
  • MA Kashem Institute of Fuel Research and Development (IFRD), Bangladesh Council of Scientific and Industrial Research (BCSIR), Dhaka 1205, Bangladesh
  • ANM Fakhruddin Department of Environmental Sciences, Jahangirnagar University, Dhaka-1342, Bangladesh

DOI:

https://doi.org/10.3329/bjsir.v55i1.46735

Keywords:

Sugarcane bagasse; Alkali treatment; Lignin; Pellet; Heating value; Pressure

Abstract

Pelletization and briquettization have been extensively used for mass and energy densification of biomass. As the demand for pellets increases, the biorefinery waste lignin can be used with the conventional raw materials for pellet preparation. Sugarcane bagasse (20-40 mesh) is treated with NaOH (8% & 16%) for bioethanol production and obtained lignin is used to prepare pellet along and with sugarcane bagasse (SB). SB, Lignin1 (8% NaOH treated SB), Lignin2 (16% NaOH treated SB) and various composition of SB and Lignin1 were used to produce pelletswith different applied pressures (5kN, 10kN, 15kN and 20kN). Pellet density and heating value were gradually increase with the applied pelletization pressure. Among the samples Lignin1 showed highest heating value at 20kN (3581.54 kcal/kg). Results revealed that 5kN is enough to produce pellet from different composition of SB and Lignin1 and the pellet composition of SB (40%) and Lignin1(60%) showed the highest heating value (3456.21 kcal/kg).

Bangladesh J. Sci. Ind. Res.55(1), 83-88, 2020

Downloads

Download data is not yet available.
Abstract
37
PDF
36

Downloads

Published

2020-04-21

How to Cite

Sujan, S., Kashem, M., & Fakhruddin, A. (2020). Lignin: a valuable feedstock for biomass pellet. Bangladesh Journal of Scientific and Industrial Research, 55(1), 83–88. https://doi.org/10.3329/bjsir.v55i1.46735

Issue

Vol. 55 No. 1 (2020)

Section

Articles

License

Bangladesh Council of Scientific and Industrial Research (BCSIR) holds the copyright to all contents published in Bangladesh Journal of Scientific and Industrial Research (BJSIR). A copyright transfer form should be signed by the author(s) and be returned to BJSIR.

The entire contents of the BJSIR are protected under Bangladesh Council of Scientific and Industrial Research (BCSIR) copyrights.

Creative Commons Licence
BJSIR is an open access journal, and articles are distributed under the terms of the Creative Commons Attribution-NonCommercial License (CC BY-NC) Creative Commons Attribution-NonCommercial 4.0 International License which allows others remix, tweak, and build upon the articles non-commercially, and although their new works must also acknowledge and be non-commercial, they don’t have to license their derivative works on the same terms.